1. Feasibility analysis of the mold design products to the computer case, for example, the first component of the product drawings using design software for group analysis, the work we are talking about the map, to ensure that the mold design before the correctness of the drawings of the product , On the other hand can be familiar with the importance of the components in the entire chassis to determine the key dimensions, which is very good in the mold design, the specific mapping method here do not do a detailed introduction.
2. In the analysis of the product to be carried out after the work of the product to analyze what kind of mold structure, and product scheduling process, to determine the contents of the process of punching, and the use of design software for product launches, the product is generally from the follow-up project Forward, for example, a product needs five processes, stamping completed in the product launch from the product drawings to the four projects, three projects, two projects, a project, and then start a graphics and then copy a copy of the previous project Of the work that completed the five works of product development work, and then meticulous work, note that this step is very important, and need to be especially careful, this step is completed, the good words in the drawing of the mold will save a lot of time, right The contents of each project after the stamping OK, including the molding die, the thickness of the product inside and outside the line to retain reservations in order to determine the size of punch and die used for product deployment methods will not be described here, will be in the product deployment method Specific introduction.
3. Preparation of materials, according to product development plans for preparation, in the drawings to determine the size of the template, including the fixed plate, stripper, punch, inserts, etc., pay attention to directly in the product development plans to prepare material, so drawing the mold is a very Big advantage, I have seen a lot of mold designers directly to the product development plans to manually calculate the preparation, this method is too low efficiency, draw the template size directly on the drawings, the group diagram in the form of a On the other hand, it saves a lot of work in the work of various parts of the mold, because only need to add positioning, dowels, guide posts and screw holes in the preparation drawing for the work of drawing each component.
4. After the preparation is completed, it can fully enter the drawing of the mold drawing, make a copy out of the preparation drawing, draw the components, such as adding screw holes, guide column holes, positioning holes and other holes, and punching die All kinds of holes to be wire-cut through the hole, in the mold, the mold gap between the upper and lower mold, we must not forget, so after the completion of these works a product mold almost completed 80%, the other in the process of drawing the mold map Need to pay attention to: the process, refers to the production, such as fitter scribing, line cutting until the different processing operations have a complete production of good layers, so that the cutting and drawing management has great benefits, such as color distinction, size The annotation is also a very important job, but also one of the most troublesome work, because it is a waste of time.
5. In the above drawing is completed, in fact, can not issue the drawings, but also to proofread the mold drawings, all the components set up, for each different mold plate making different layers, and the same benchmark such as pillar holes until the mold Group analysis, and the process of opening the product map into the group diagram, to ensure that the holes in the template and the bending position of the upper and lower mold gap is correct.